In This Section +

Installation Instructions - Epoxy fixed Tactiles up to 60 LM

The following set of diagrams are simple installation instructions to self-install our Polyurethane or Stainless Steel Tactile Indicators. This instruction set is for Tactile quantities over 7.5 Lineal Metres (LM = 1.0 x 0.6m). It utilises TacPro's patented full size epoxy applicator gun with precision dosing system for use with our 900ml twin tube epoxy cartidges.

You will need:

Tools required for installation of TacPro tactile indicators

Measure layout and set rubber drilling templatesDrill holes for the TGSI






Vacuum out the concrete dustAssemble epoxy gun and dosing system






Accurately dose each hole with epoxy





Tap the tactile studs flush with the ground

Twist the stainless steel tactiles into position

JavaScript is required in order fully to use this site. Please enable it now and reload the page.