In This Section +

Installation Instructions - Epoxy fixed Tactiles up to 7.5 LM

The following set of diagrams are simple installation instructions to self-install our Polyurethane or Stainless Steel Tactile Indicators. This instruction set is for Tactile quantities up to 7.5 Lineal Metres (LM = 1.0 x 0.6m). It utilises TacPro's smaller epoxy applicator gun with our patented precision dosing system for use with our 450ml twin tube epoxy cartidges.

You will need:

Tools required for installation of TacPro tactile indicators

Measure layout and set rubber drilling templatesDrill holes for the TGSI

 

 

 

 

 

Vacuum out the concrete dustAssemble epoxy gun and dosing system

 

 

 

 

 

Accurately dose each hole with epoxy

 

 

 

 

Tap the tactile studs flush with the ground

Twist the stainless steel tactiles into position

JavaScript is required in order fully to use this site. Please enable it now and reload the page.